The primary goal of the training is to acquire necessary knowledge and skills to be able to seamlessly program Niagara Enabled Controllers (RAC18-IP, VAV14-IP) which are powered by the nano EDGE ENGINE.
Niagara Enabled Controllers can be programmed in two ways:
Using iC Tool – the primary tool featured in this training.
Using iC Niagara Workbench – demonstrated in our NE2 Link training module, available [HERE].
Training’s objective is also to highlight key features of the new nano EDGE ENGINE and it’s use cases.
No previous experience with iSMA devices is required.
Entire material of the training course is free and available for everyone, however there are practical exercises which can only be done having physical devices on your disposal.
To maximize your learning experience and effectively perform the practical exercises, we highly recommend the acquisition of the RAC18-IP/VAV14-IP and TP devices. These specific devices will allow you to directly and confidently engage with the course content.
To buy necessary equipment, contact your supply partner or iSMA CONTROLLI directly at orders@ismacontrolli.com.
Course Includes
- 12 Lessons
- 3 Topics
