Lesson 1, Topic 7
In Progress

Backward Compatibility and Migration from TP 1.0

Lesson Progress
0% Complete

All Touch Point 2.0 models are backward compatible with the previous generation. This applies to the three model groups that existed in 1.0:

  • TP-DISP-2
  • TP-VAV-DISP-2
  • TP-NS-2

In practice this means that a 2.0 panel can replace a 1.0 panel in an existing installation, and that 1.0 and 2.0 panels can coexist on the same bus. The wiring, the Smart Plug daisy-chain connection and the screw connector are unchanged, so no rewiring is needed.

Working with iSMA CONTROLLI controllers

Touch Point 2.0 panels work with the same controllers as the previous generation:

ControllerPlatformCovered in
iSMA-B-FCUFan coil unit controllerLesson 3
RAC18-IPnano EDGE ENGINE room application controllerLesson 3
ZAC24-IP-Dnano EDGE ENGINE zone controller with DALI-2Lessons 3 and 5
Third-party controllersModbus RTU / BACnet MS/TPLesson 6
The Smart Plug daisy-chain is the reason a Touch Point installation needs so little cabling: panels are chained on a single bus back to the controller, without additional gateways or a second protocol.
Touch Point 2.0 replaces the 1.0 generation in the offer. For new projects, always specify 2.0 models.
MAC36PRO: VPN Connection Setup